NOTICE:
Rock mucking loader is a machine that loads ore or rock in a horizontal or gently inclined tunnel. So what is the process of mucking machine operation?
1. Before starting the rock mucking loader, check the power supply switch, whether the cable is in good condition, and whether there is any leakage. After confirming that the guarantee is completed, the drive can be started.
2. Strictly knock on the top of the tunnel mucking machine before working, deal with the pumice stone of the net top, and pay attention to it at any time. If the situation is critical, you should evacuate immediately.
3. When loading the rock mucking loader, you should wear insulating gloves and insulating boots (keep intact), choose a reasonable position, and the clearance behind the driver is not less than 40cm. Head and feet cannot reach the bucket's range of movement, and two people are prohibited from operating a mucking machine at the same time.
4. Within the scope of tunnel mucking machine work, other irrelevant personnel are forbidden to enter. When the working surface must be entered due to work needs, it must wait for the rock mucking loader to stop before entering.
5. When mucking machine loading rocks, the pusher should stand on the side of the mine cart, do not stand behind the mine cart, and always pay attention to flying rocks hurting people. It is forbidden to hold the mine cart by hand, and the cart worker must wear insulating gloves when helping to pull the cable.
6. When the mucking machine is overhauled, it is necessary to cut off the power supply in time, and it is forbidden to carry out overhaul with power on.
The above is the operation process of the tunnel mucking machine, so the staff must pay attention to the operation process to avoid accidents.
